Freezer Archives

Whirlpool Electric Dryer – Won’t Start

March 10, 2021

Thanks for watching, this video shows how to diagnose the most common issues that will cause a dryer not to start. This video is for simple electric dryers, with a mechanical timer.

Whirlpool Electric Dryer – Won’t Start

03/10/2021

Thanks for watching, this video shows how to diagnose the most common issues that will cause a dryer not to start. This video is for simple electric dryers, with a mechanical timer.

02/26/2021

This Kenmore Elite Dryer was having trouble with mode selection; the buttons were stuck and would not switch between different modes. It would beep randomly, and many of the buttons on the dryer would not work. It would run, but only in one setting. We were able to remove the ribbon from the user interface and control board on the dryer and clean it with electrical cleaner, so that the signal now goes back and forth without error.

02/22/2021

If your refrigerator is not running at all, you hear no fans running and there is no cooling happening in the fridge or freezer, you may have a faulty defrost timer. We show you how to check the defrost timer by using a screwdriver to manually override the switch. If you can do this, then you need to replace the timer. You can find these on Amazon. We also show you how to test the cold control, which is basically a thermostat that you can check with a multi-meter. Supco UET120 Refrigerator Defrost Timer Control Universal 120 Volt Electronic

01/28/2021

We’ll walk you through what to check first to identify that the problem is occurring at your refrigerator compressor.

01/08/2021

In this video we show you how to replace the agitator dogs. You may have noticed that your clothes aren’t as clean, or they are in the same position that you left them, meaning the agitator didn’t tumble them over and clean them properly. Replace the plastic agitator dogs and you should be good as new. Thanks for watching our DIY Videos.

01/05/2021

Ever experienced this error code on your dishwasher? Could be your exhaust fan. Watch this to learn how to diagnose this problem.

12/19/2020

We repaired this KitchenAid Mixer by replacing the worm gear and completely cleaning out the transmission housing. Be sure to check all of the gears, remove any chipped or broken pieces and replace them, then liberally re-grease the transmission and worm gear. Thanks for watching.

10/21/2020

10/09/2020

09/09/2020

This kegerator was accumulating ice from an air leak created during installation of the taps. We solved that problem, and you can too. Thanks for watching!

08/18/2020

This Roper washer was not agitating or spinning. There was a loud rattling coming from the bottom, if you hear this and have a similar problem, it could be your transmission coupling. In this case, our coupling had rounded itself out, along with the motor spindle, requiring a replacement of both.

07/16/2020

07/05/2020

If you have a GE Profile refrigerator that is not cooling/freezing due to flood damage, take a look at the most likely cause. You can do this check without a multimeter, but a multimeter would confirm the failure. Before you try to work on it, UNPLUG IT!

06/30/2020

If you have a front-load washer, this is something you should be aware of. Many units come with a Stainless Steel inner drum which is matted to an Aluminum support assembly, also known as a “spider.” The problem occurs when you have too much soap running in your machine over an extended period of time. The soapy solution tends to be very basic and will react with the aluminum backing plate forming corrosion much like you would find around battery terminals. Eventually the plate gets degraded like the one shown in our video and can lead to further damage inside your washer.

06/18/2020

DO NOT BYPASS FUSES IN YOUR DRYER! They are there for a reason. There are consequences.

02/07/2020

If you have a GE Washer that begins the wash cycle but will not agitate, the problem could be the agitator coupling. Check to make sure that the basket spins during the drain cycle, as this indicates the motor and transmission are likely operating correctly.

02/06/2020

If you have a front-load washer that’s not turning on, the problem can range from a tripped breaker, to a burned out fuse, to something not worth repairing at all. Here are a few things you can check.

Call Us Today! 318-459-8745

Whirlpool Electric Dryer – Won’t Start

Archives

Categories

Whirlpool Electric Dryer – Won’t Start

Kenmore Elite Dryer – Buttons Don’t Work

Refrigerator Not Cooling At All – Defrost Timer

Repair Refrigerator Not Cooling – How to Start a Cold Compressor

Top-Load Washer Agitator Broken – Agitator Dogs

Dishwasher – UO Error Code

KitchenAid Mixer Repair – Worm Gear

EbE Error Code – Frigidaire Affinity Washer

Washer Bleach Tray – Corrosion Fix

Kegerator Repair (Ice Build-Up)

Roper Washer Draining, but not Agitating or Spinning

LG Front-Load Washer – IE Error Code

Repairing a GE Profile Refrigerator due to Flood Damage

Corrosion of Rear Drum Assembly (aka Spider)

Do Not Bypass Dryer Fuses

Replacing GE Washer Agitator

Front-Load Washer – No Power At All

Archives

Categories

Quick Links

Contact Us

Product Enquiry